Toro MMX-650E-S Operator's Manual page 15

2. Ensure that the tires are inflated to the correct
air pressure. The following Tire Air Pressure
table shows the appropriate air pressure for the
tires as installed at the factory.
Important:
Always check the information on
the actual tires for the correct air pressure
requirement.
Important:
The most common cause of tire
trouble is under-inflation. Maintain full air
pressure.
Tire Air Pressure
Model
68012
68018, 68019
3. Ensure that the wheel lug nuts are torqued to
108 to 122 N-m (80 to 90 ft-lb).
Note:
Check the torque of the wheel lug nuts
initially and after towing.
Note:
Torque the lug nuts in the sequence
shown in Figure
Figure 16
Tire pressure
Max 414 kPa (60 psi)
Max 241 kPa (35 psi)
16.
Hitching a Machine with a Stamped
Ball Coupler
1. Apply chassis grease to the socket of the
coupler and the area of the clamp that contacts
the ball. Oil the pivot points and sliding surfaces
of the coupler with SAE 30 motor oil.
2. Open the coupler latch
g021107
1. Bail
3. Position the coupler on top of the hitch ball
(Figure 17).
4. Close the coupler latch
5. Open the bail on the safety pin and insert the pin
through the hole in the latch
6. Rotate the free end of the bail over the end of
the safety pin that is protruding through the latch
(Figure 17).
15
(Figure 17).
Figure 17
2. Safety pin
(Figure 17).
(Figure 17).
g020359