Lubrication; Lubricating The Machine; Engine Maintenance; Servicing The Air Cleaner - Toro CM-658H-S Operator's Manual

Lubrication

Lubricating the Machine

Service Interval: Monthly—Grease the trunnions and the
drum spindle.
1. Clean around each grease fitting with a rag, and lift the
plastic cap off the grease fitting (Figure 42).
2. Use a grease gun to lubricate the grease fittings of both
trunnions and the drum spindle with general-purpose
lithium grease (Figure 42).
3. Wipe up any excess grease.
Figure 42
Important: Do not lubricate the pinion gear and ring
gear. Lubrication will cause them to collect abrasive
materials and accelerate wear.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Inspect the
Every 50 hours—Clean the air-cleaner elements. Clean
them more frequently in dusty operating conditions.
Every 300 hours/Yearly (whichever comes
first)—Replace the paper air-cleaner element. Replace
it more frequently in dusty operating conditions.
Important: Do not operate the engine without the
air-filter assembly; extreme engine damage will occur.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-plug Wire (page 27).
3. Remove the nut that secures the cover (Figure 43).
G019678
6
1. Cover nut
2. Cover
3. Wing nut
29
air-cleaner elements.
1
2
3
4
5
Figure 43
4. Foam element
5. Paper element
6. Base
G019728