Table of Contents
Advertisement
Figure 31
1. Pillow-block bearings
2. Rear trunnion
2.
Pump grease into each fitting as follows:
•
For the pillow-block bearings, pump 1 shot of
grease into each fitting
•
For the trunnions, pump several shots of
grease into each fitting until it starts to ooze
out of the bearing housing
Important:
Pump grease in slowly and
carefully to prevent damage to the bearing
seals.
3.
Wipe up any excess grease.
g021101
3. Front trunnion
(Figure
31).
(Figure
31).
Lubricating the Motor
Bearings
Service Interval: Every 6,000 hours
Grease type: electric-motor bearing grease
1.
Clean around each grease fitting with a rag.
2.
Pump 1 or 2 shots of grease into each fitting
(Figure
32).
Important:
Do not over-lubricate the motor.
3.
Wipe up any excess grease.
27
Figure 32
g021588
Advertisement
Table of Contents
