Table of Contents
Advertisement
Installing the Divider Plate
1.
Guide the divider plate into position against the
front cowl.
Note:
Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise
while lowering it into position.
Ensure that the divider plate is not backward.
Figure 30
2.
Align the bolt holes in the divider plate and the
front cowl.
3.
Install each of the 4 bolts, and hand-tighten
them to prevent cross-threading.
4.
Tighten the bolts with a wrench until they are
secure.
Lubrication
Lubricating the Bearings
and Seals
Service Interval: After each use—Lubricate the
Monthly—Lubricate the pillow-block bearings.
Note:
The pillow-block bearings are inside the
cowl—remove the divider plate to access them; refer
to
Removing the Divider Plate (page
Grease type: #2 general-purpose lithium-based
grease.
1.
Clean around each grease fitting with a rag and
lift the plastic cap off the grease fitting
31).
g021586
26
trunnions.
25).
(Figure
Advertisement
Table of Contents
