Disconnecting The Spark-Plug Wire; Removing The Divider Plate; Installing The Divider Plate - Toro CM-658H-S Operator's Manual

Disconnecting the
Spark-Plug Wire
Pull the spark-plug wire off the terminal of the spark
plug (Figure 38).
Figure 38
1. Spark plug

Removing the Divider Plate

If your model has a divider plate, you may need
to remove it before performing some maintenance
procedures:
1. Open the cowl.
2. Use a wrench to remove the 4 bolts that secure
the divider plate to the front cowl.
Note:
Retain the fasteners for installing the
divider plate.
Figure 39
3. To remove the divider plate, lift it upward and tilt
it back so that it clears various components.

Installing the Divider Plate

When finished performing maintenance, install the
divider plate as follows:
1. Guide the divider plate into position against the
front cowl.
Note:
Start with the divider plate tilted slightly
back, then tilt it forward while lowering it into
position.
g019281
2. Align the bolt holes in the divider plate and the
front cowl.
3. Install each of the 4 bolts and hand-tighten them
to prevent cross-threading.
4. Tighten the bolts with a wrench until they are
secure.
g021094
30
Figure 40
g021102