Toro CM-658H-S Operator's Manual page 11

2
Installing the Tongue
End-Dump Models Only
Parts needed for this procedure:
1 Tongue
1 Front stabilizer leg
6 Short bolt
1 Long bolt
7 Nut
Procedure
1. Lower the rear stabilizer legs; refer to
the Stabilizer Legs (page
2. Place jack stands under the front frame rail
to prevent the machine from tipping forward
(Figure 5).
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
1. Support points
3. Remove the 2 nuts and bolts that secure the
front stabilizer leg to the frame
remove the front stabilizer leg.
Lowering
22).
Figure 5
(Figure 6) and
1. Front stabilizer leg
4. Install the tongue into the opening at the front
of the machine and secure it with 6 nuts and
short bolts torqued to 102 N∙m (75 ft-lb); refer
to Figure
1. Clevis pin
2. Long bolt
3. Short bolt
5. Align the top rear hole in the front stabilizer leg
to the hole past the handle in the front of the
tongue (Figure
6. Install the long bolt through the holes and secure
it with a nut torqued to 102 N∙m (75 ft-lb); refer
to Figure
Note:
The stabilizer leg pivots rearward on the
bolt. If you install the bolt into the wrong hole,
g021091
the stabilizer leg will not work properly.
7. Insert the clevis pin to lock the front stabilizer leg
in position
11
Figure 6
7.
Figure 7
4. Nut
5. Tongue
6. Front stabilizer leg
7).
7.
(Figure 7).
g021092
g021093