Toro CM-658H-S Operator's Manual page 17

Preparing the Machine for Towing
1. Shut-off the engine and fuel valve.
2. Empty the drum.
3. Using the handwheel, position the drum so that it
is pointing down toward the ground
Figure 16
1. Drum pointing down
2. Drum-tilt brake engaged
4. Lock the drum into position by pushing down the
drum-tilt-brake handle
Figure 17
Drum-Tilt Brake
1. Unlocked position
5. Close the engine cowl and secure the cowl
latches (Figure 18).
(Figure 16).
g019806
3. Tow pole bolted in place
(Figure 17).
g019733
2. Locked position
6. Inspect the tires; refer to
(page 37).
Raising the Stabilizer Legs
End-Dump Models Only
End-dump models have a front stabilizer leg and 2
rear stabilizer legs.
Raise the stabilizer legs before towing the machine.
1. Adjust the machine so that there is no weight
resting on the rear stabilizer legs.
2. Pull the clevis pin out from 1 of the rear stabilizer
legs and the bracket
17
Figure 18
Inspecting the Tires
(Figure 19).
Figure 19
g019741
g019917