Toro CM-658H-S Operator's Manual page 18

3. Slide the stabilizer leg up in the bracket and
align the pin hole of the bracket with the lower
hole in the stabilizer leg
4. Push the clevis pin through the hole in the
bracket and the stabilizer leg
5. Repeat steps 1 through
stabilizer leg.
6. Lift upward on the tongue so that there is no
weight resting on the front stabilizer leg.
7. Pull the clevis pin out from the front stabilizer leg
and the tongue (Figure
Figure 20
1. Remove the clevis pin.
2. Rotate the stabilizer leg
up.
8. Rotate the front stabilizer leg up into the tongue
(Figure 20).
9. Push the clevis pin through the rearward hole in
the tongue and the front stabilizer leg
20).
(Figure 19).
(Figure 19).
4 for the other rear
20).
g019915
3. Install the clevis pin.
(Figure
Hitching the Machine to a Tow
Vehicle
Your machine is equipped with 1 of the following
hitch types; hitch it as described in the appropriate
procedure:
•
Stamped-ball coupler—
Coupler (page 18)
•
Forged-ball coupler—
Coupler (page 19)
•
Pintle-hitch coupler—
Coupler (page 19)
•
Pin-hitch coupler—
(page 20)
Hitching a Stamped-Ball Coupler
1. Apply chassis grease to the socket of the coupler
and the area of the clamp that contacts the ball.
2. Oil the pivot points and sliding surfaces of the
coupler with SAE 30 motor oil.
3. Hitch the machine as shown in
18
Hitching a Stamped-Ball
Hitching a Forged-Ball
Hitching a Pintle-Hitch
Hitching a Pin-Hitch Coupler
Figure 21.