Controls; Engine Controls - Toro CM-658H-S Operator's Manual

Controls

Become familiar with all of the controls before you
start the engine and operate the machine.
Engine Switch
When the engine switch on the cowl is in the R
position, it allows the engine to run. Moving the engine
switch to the S position shuts off the engine.
TOP

Engine Controls

Figure 12
1. Recoil-start handle
2. Fuel valve
3. Choke lever
4. Throttle lever
Fuel Valve
The fuel valve (Figure
choke lever. Move the lever for the fuel valve to the
O position before attempting to start the engine.
N
When you have finished mixing, shut off the engine
and move the fuel-valve lever to the O
5. Fuel cap
6. Oil dipstick
7. Oil-drain plug
8. On/Off switch
13) is located underneath the
position.
FF
UN
1. Fuel valve
2. Choke lever
Choke Lever
Use the choke lever
Before pulling the recoil-start handle, move the choke
lever to the C
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
Throttle Lever
g019744
The throttle lever
of the engine. It is located next to the choke lever. It
sets the engine speed and therefore can increase and
decrease the rotation speed of the mixing paddles.
For best performance, set this control to the F
position when mixing material.
Engine On/Off Switch
The On/Off switch is located on the front of the engine.
•
Rotate it to the O
engine.
•
Rotate it to the O
14
Figure 13
3. Throttle lever
(Figure 13) to start a cold engine.
position. Once the engine is
LOSED
(Figure 13) controls the speed (rpm)
position to start and run the
N
position to shut off the engine.
FF
g018792
position.
PEN
AST