Drive System Maintenance; Tire Air Pressure; Inspecting The Tires - Toro CM-658H-S Operator's Manual

9. Align the O-ring in to the groove in the sediment
cup and install the sediment cup to the fuel-valve
housing.
10. Move the lever of the fuel valve to the O
position (all the way to the right) and check for
leaks. If it leaks, replace the O-ring.
Drive System
Maintenance
N

Tire Air Pressure

The following table shows the appropriate air pressure
for the tires as installed at the factory.
Important:
the actual tires for the correct air pressure
requirement.
Model
68004
68006, 68007, 68008, 68009,
and 68011

Inspecting the Tires

Service Interval: Before each use or daily
WARNING
Failure to maintain correct tire pressure
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings
Note:
Ensure that any tires installed on your machine
meet or exceed the weight requirements of your
machine as listed in
1. Visually inspect the tires for damage and wear
(Figure 52
37
Always check the information on
Maximum Air Pressure
414 kPa (60 psi)
241 kPa (35 psi)
Specifications (page
and Figure 53).
15).