Setup; Installing The Tow Pole; Installing The Tongue - Toro CM-658H-S Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Tow Pole

Side-Dump Models Only
Parts needed for this procedure:
1 Tow pole kit (sold separately)
Tow Pole Specifications
Purchase the tow pole kit (including fasteners) that
meets your needs from your Authorized Service
Dealer. The machine has the following tow pole
options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
Installing the Tow Pole
1. Remove the bolt and nut from the tow pole
(Figure 4).
Description
Tow pole kit (sold separately)
Tongue
Front stabilizer leg
Short bolt
Long bolt
Nut
Safety chain
Connecting link
Length
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
Qty.
Install the tow pole (side-dump models
1
only).
1
1
Install the tongue (end-dump models
6
only).
1
7
1
Install the safety chain.
2
1. Tow pole
2. Front post
3. Bolt
2. Slide the tow pole forward and align the hole in
the pole with the hole in the frame fitting
4).
3. Insert the bolt through the holes in the fitting and
the pole (Figure
4. Thread the nut onto the bolt and tighten them
until they are tight against the frame fitting
(Figure 4).
Note:
If the self-locking nylon insert in the
locknut wears with use, replace the nut with a
new Grade 5 or Grade 8 locknut.
10
Use
Figure 4
4. Bolt hole
5. Frame fitting
6. Nut
4).
g019804
(Figure