Changing The Engine Oil And Filter; Servicing The Air Cleaner - Toro Groundsmaster 4100 Operator's Manual

Check the engine-oil level; refer to
Figure 86
Note:
When using different oil, drain all old oil from
the crankcase before adding new oil.
Crankcase Oil Capacity
Approximately 5.7 L (6 US qt) with the filter.
Changing the Engine Oil
and Filter
Service Interval: After the first 50 hours
Every 250 hours
1. Start the engine and let it run 5 minutes to allow
the oil to warm up.
2. With the machine parked on a level surface,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Replace the engine oil and filter
Figure 86.
g031256
(Figure 87).
64
Figure 87
4. Add oil to the crankcase.

Servicing the Air Cleaner

Service Interval: Before each use or daily—Check
the air-cleaner indicator
Every 50 hours—Inspect the air cleaner.
Every 400 hours—Service the air cleaner
(earlier if the air cleaner indicator shows red,
and more frequently in extremely dirty or dusty
conditions).
Check the air-cleaner body for damage, which could
cause an air leak. Replace it if it is damaged. Check
the whole intake system for leaks, damage, or loose
hose clamps.
Service the air-cleaner filter only when the service
indicator requires it (Figure
before it is necessary only increases the chance of
dirt entering the engine when you remove the filter.
g031675
88). Changing the air filter