Setting The Project Options - Xilinx LogiCORE IP Spartan-6 Getting Started Manual

Setting the Project Options

Set the project options using the following steps:
1.
2.
3.
4.
5.
6.
X-Ref Target - Figure 3-3
Spartan-6 FPGA GTP Transceiver Wizard v1.8
UG546 (v1.8) December 14, 2010
Click Part in the option tree.
Select Spartan6 from the Family list.
Select a Spartan-6 FPGA from the Device list which supports GTP transceivers.
Select an appropriate package from the Package list. This example uses the
XC6SLX45T device (see Figure
Note:
If an unsupported silicon family is selected, the Spartan-6 FPGA GTP Transceiver
Wizard remains light grey in the taxonomy tree and cannot be customized. Only Spartan-6 FPGA
devices containing GTPA1_DUAL transceiver primitives are supported by the Wizard. See the
Spartan-6 Family Overview for a list of devices containing GTPA1_DUAL transceiver primitives.
Click Generation in the option tree and select either Verilog or VHDL as the output
language.
Click OK.
Figure 3-3: Target Architecture Setting
www.xilinx.com
3-3).
Setting Up the Project
17