Logging In To The Mm910 Cli Over A Network Port By Using Putty - Huawei CX320 User Manual

CX320 Switch Module
User Guide
----End
6.2 Logging In to the MM910 CLI Over a Network Port by
Using PuTTY
This topic describes how to use PuTTY to remotely log in to a server over a local area
network (LAN) and to configure and maintain the server.
Prerequisites
Data
l
l
Software
PuTTY.exe: third-party software used for remote access on various platforms.
Procedure
Step 1 Connect the local PC and the MGMT port on the MM910 through a network cable.
Step 2 Set an IP address and a subnet mask or add route information for the PC to enable
communication between the PC and the MM910.
To check the connectivity between the PC and the device, run the Ping MM910 IP address
command on the PC CLI.
Step 3 Double-click PuTTY.exe.
The PuTTY Configuration window is displayed.
Step 4 In the navigation tree on the left, choose Connection > SSH.
Step 5 Set the login parameters as follows:
l
l
l
l
Issue 09 (2019-08-02)
NOTE
l Only one serial port connection can be set up at a time. Exit the SOL interface after the operation.
l You can press Ctrl+R to return to the CLI for selecting a slot in the chassis, as shown in
you can press ctrl+r twice to log out of the SOL CLI.
NOTE
l The compute nodes and switch modules of the E9000 do not provide the MGMT management port.
l To log in to a compute node or switch module, see
MM910 SOL.
IP address of the MM910 to be connected
User name and password for logging in to the MM910
Host Name (or IP address): Enter the IP address of the MM910 to be logged in to, for
example, 191.100.34.32.
Port: Use the default value 22.
Connection type: Use the default value SSH.
Close window on exit: Use the default value Only on clean exit.
Copyright © Huawei Technologies Co., Ltd.
6 Common Operations
6.1 Logging In to or a Switch Module over
Step 3. And
85