Checking The Switching Plane - Huawei CX320 User Manual

CX320 Switch Module
User Guide
l If the MGMT port on the active MM910 is already connected with a network cable, do
l If you want to connect your local PC directly to the MM910 using a network cable but the
Step 2 Use an SSH connection tool to log in to the MM910 CLI by using the floating IP address of
the MM910s.
This topic describes how to use PuTTY to log in over SSH. For details, see
the MM910 CLI Over a Network Port by Using
Step 3 Log in to the CLI of a switching plane over MM910 SOL.
For details, see
----End
l
Step 1 Use a DB9-RJ45 cable to connect the RS232 serial port of the PC to the SYS serial port on
the CX320 panel.
Step 2 Use a serial port communication tool to log in to the CLI of a switching plane.
Set the key communication parameters as follows:
l
l
l
l
l
l
In this document, PuTTY is used as an example for login over a serial port. For details, see
6.3 Logging In to a Device Over a Serial Port by Using
----End

4.5 Checking the Switching Plane

Check the converged switching plane operating status of the CX320.
Issue 09 (2019-08-02)
not remove the network cable from the MGMT port. Otherwise, an active/standby
switchover of the MM910s will be triggered, which may cause network interruption.
MGMT port on the active MM910 is already connected with a network cable, connect the
network cable from the local PC to the STACK port of the active MM910 in the chassis. If
the STACK port on the active MM910 is also used, connect the network cable to an idle
STACK port on an active MM910 in a chassis cascaded with the E9000 chassis.
6.1 Logging In to or a Switch Module over MM910
Log in to the CLI of a switching plane over a serial port.
Serial line to connect to: COMn
Speed (baud): 115200
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
NOTE
n indicates the serial port number and is an integer.
Copyright © Huawei Technologies Co., Ltd.
4 Configuring the CX320
PuTTY.
SOL.
PuTTY.
6.2 Logging In to
62