Acs880 Minimum Required Parameter Settings For Profinet; Acs880 More Parameters Read From Drive To Plc (Optional) - ABB ACS355 Series Quick Start Up Manual

37

ACS880 Minimum required parameter settings for PROFINET

The minimum required parameter settings based on factory default settings.
Parameter Description
50.01 FBA A Enable
51.01 FBA A ype
51.02 Protocol/Profile
51.04 IP Configuration
51.05 ... IP address
51.08
51.09 Subnet CDR
51.27 FBA PAR
REFRESH
20.01 Ext 1 commands
22.11 Speed ref1
selection
31.11 Fault reset
selection
(46.01) Speed scaling

ACS880 More parameters read from drive to PLC (optional)

Parameter Description
52.03 ...
Actual value or
52.12 parameter of drive
51.27 FBA PAR
REFRESH
Setting
Enable
Ethernet
PNIO ABB Pro (11)
Static (0)
192.xxx.xx.xx or any other
required IP address.
24
REFRESH
Fieldbus A
FB A ref1
P.06.01 bit 7
[Scale max]
Setting Comment
GGii GG = parameter group, ii = parameter index
example, 0107 = actual current; 3501 = motor est.
temp
REFRESH Updates fieldbus settings (groups 50 to 57)
Comment
Activates fieldbus module.
Filedbus type.
Communication profile ABB drives.
-
-
24 For subnet mask 255.255.255.0.
Updates fieldbus settings (groups 51
to 55).
Fieldbus interface as source for start
and stop.
Fieldbus interface as source for
speed reference.
Fieldbus interface as source for fault
reset.
Max speed/frequency scaling value
(used in function block/visualization
input SPEED_REF_MAX). Must be
less or equal to drive parameter max
speed/frequency.