ABB ACS355 Series Quick Start Up Manual page 103

103
140 Cannot change mode to TORQUE (frequency is used)
150 Internal buffer overflow
160 Internal communication error
DP-V1 error table
Error no. Meaning
00h Impermissible parameter number
01h Parameter value cannot be changed
02h Low or high limit exceeded.
03h Invalid subindex
04h No array
05h Incorrect data type
06h Setting not permitted (can only be reset)
07h Description element cannot be changed
09h No description data available
0Bh No operation priority
0Fh No text array available
11h Request cannot be executed because of
operating mode
14h Value impermissible
15h Response too long
Used at
Access to unavailable parameter
Change access to a parameter value that
cannot be changed
Change access with value outside the limits.
Access to unavailable subindex
Access with subindex to non-indexed
parameter
Change access with value that does not match
the data type of the parameter
Change access with value unequal to 0 when
this is not permitted
Change access to a description element that
cannot be changed
Access to unavailable description (parameter
value is available)
Change access rights without rights to change
parameters.
Access to text array that is not available
(parameter value is available)
Access is temporarily not possible for reasons
that are not specified in detail
Change access with a value that is within limits
but is not permissible for other long-term
reasons (parameter with defined single values)
The length of the current response exceeds the
maximum transmittable length