Ip Addresses And Workgroups - ABB IndustrialIT Compact HMI 800 Getting Started

IP Addresses and Workgroups

IP Addresses and Workgroups
Compact HMI 800 is delivered with preset IP addresses. If you have two systems
they will have the same IP addresses by default.
If a Compact HMI 800 system is extended with additional client nodes ordered
separately, those are always configured as Workplace Client 4. So if this node
already exist the addresses needs to be reconfigured.
The pre loaded addresses are shown in
change IP addresses, follow the scheme below:
1. Log in as System Administrator.
2. Change the IP address of the computer from the Windows control panel.
3. Update the Host file in the server and all clients to reflect the changed address.
The file can be found in the following path:
C:\WINDOWS\system32\drivers\ets\hosts.
The file can be updated using Notepad.
4. Restart each computer after changing the IP addresses.
Below the IP addresses for the different network nodes are presented. The system is
interconnected using Work Groups with the nodes defined in a Host table. This
means that a standalone system does not need a Domain Server or a DNS server.
If the installation shall be included in an existing domain, please refer to the
Industrial
• Section 3 for network issues
• Section 4 for Domain and DNS issues.
In Table 5
are presented.
Server pre installed network card
Optionally - Server network card 2
44
IT
Base System, Automation System Network instruction:
the pre loaded or predefined IP addresses for a Compact HMI 800 system
Table 5. Nodes and IP Addresses
Node
Table 5. If you for some reason need to
IP Address
172.16.4.21
172.16.4.11
Section 3 Installation
3BSE040587R4401