Table of Contents
Advertisement
Section 7 Administration
Change the Windows Computer Name in the Client Node
To change the Windows Computer Name of a Compact HMI 800 Client node please
go through the following steps
1.
Log in as SysAdmin.
2.
Disconnect the client form the servers as described in chapter
Disconnect Client Nodes
3.
Change the Computer Name and or IP address of the client.
4.
Update the Hosts file in the client and the server with the changes
("C:\WINDOWS\system32\drivers\etc\hosts").
5.
Remember that if the name of the server has been changed, the License Status
Viewer should be opened, and the CLS machine be changed.
6.
Connect the client to the server as described in chapter
Client Nodes
7.
The node name change of the client is now ready.
Connect and Disconnect Client Nodes
Client nodes has to be connected to the system. This is done in the following steps:
1.
Connect the client node to the network.
2.
Log in on the server node as SysAdmin.
3.
Start the Configuration Wizard.
4.
Select System Administration and click Next, and Next again.
5.
Select Nodes and click Next.
6.
Select Add Client and click Next.
7.
In the dialog shown below select the client to be added e.g. HMI-Client01.
3BSE040587R4401
Change the Windows Computer Name in the Client Node
on page 135.
on page 135.
Connect and
Connect and Disconnect
135
Hide quick links:
Advertisement
Table of Contents
