Installation And Configuration Of Opc Servers For Plcs - ABB IndustrialIT Compact HMI 800 Getting Started

Installation and Configuration of OPC Servers for PLCs

If the Alarm and Event OPC server for AC 800M controllers is not used, the related
event collector service may be switched off to get an all green system status
structure. This is done by logging in as SysAdmin, and removing the enabled switch
in the
Figure 8. Event Collector Switched off
Installation and Configuration of OPC Servers for PLCs
Compact HMI 800 can interface to standard PLCs. The connection is done using a
specific communication driver, or via an OPC server for the PLC. To connect one or
more PLCs via an OPC server follow the description below.
Install the OPC server for the PLC. The OPC server shall be installed as a Windows
service if possible. Below is a typical workflow how to install and set up an OPC
server to correctly interface the Compact HMI 800 software.
34
Figure 8.
Section 3 Installation
3BSE040587R4401