ABB ACSM1 Firmware Manual page 67

1.22 INVERTER POWER
Drive output power in kilowatts.
1.26 ON TIME COUNTER
This counter runs when the drive is powered. The counter can be reset using the DriveStudio tool.
1.27 RUN TIME COUNTER
Motor run time counter. The counter run when the drive modulates. The counter can be reset using
the DriveStudio tool.
1.28 FAN ON-TIME
Running time of the drive cooling fan. Can be reset by entering 0.
1.31 MECH TIME CONST
Mechanical time constant of the drive and the machinery as determined by the speed controller
autotune function. See parameter
1.38 TEMP INT BOARD
Measured temperature of the interface board in degrees Celsius.
1.39 OUTPUT VOLTAGE
Calculated motor voltage.
1.42 FAN START COUNT
Number of times the drive cooling fan has been started.
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
28.16 PI TUNE MODE
FW block: ACTUAL VALUES
FW block: None
FW block: None
(see above)
(see above)
(see above)
(see above)
(see above)
on page 140.
(see above)
Parameters and firmware blocks
67