ABB ACSM1 Firmware Manual page 147

33.09 SUPERV3 FUNC
Selects the mode of supervision 3.
(0) Disabled
(1) Low
(2) High
(3) Abs Low
(4) Abs High
33.10 SUPERV3 ACT
Selects the signal to be monitored by supervision 3. See parameter
Value pointer: Group and index
33.11 SUPERV3 LIM HI
Sets the upper limit for supervision 3. See parameter
-32768...32768
33.12 SUPERV3 LIM LO
Sets the lower limit for supervision 3. See parameter
-32768...32768
33.17 BIT0 INVERT SRC
Parameters 33.17...33.22
shown by parameter
This parameter selects the source bit whose inverted value is shown by parameter
INVERTED SW, bit 0.
DI1
DI2
DI3
FW block: SUPERVISION
Supervision 3 not in use.
When the signal selected by parameter
below the value of parameter
SUPERV STATUS
exceed the value of parameter
When the signal selected by parameter
exceeds the value of parameter
SUPERV STATUS
below the value of parameter
When the absolute value of the signal selected by parameter
SUPERV3 ACT
LIM LO, bit 2 of
the absolute value of the signal must exceed the value of parameter
33.11 SUPERV3 LIM
When the absolute value of the signal selected by parameter
SUPERV3 ACT
HI, bit 2 of 6.14 SUPERV STATUS
absolute value of the signal must fall below the value of parameter
33.12 SUPERV3 LIM
FW block: SUPERVISION
FW block: SUPERVISION
Upper limit for supervision 3.
FW block: SUPERVISION
Lower limit for supervision 3.
FW block: None
enable the inversion of freely selectable source bits. The inverted bits are
6.17 BIT INVERTED SW.
Digital input DI1 (as indicated by
Digital input DI2 (as indicated by
Digital input DI3 (as indicated by
(see above)
33.10 SUPERV3 ACT
33.12 SUPERV3 LIM
is activated. To clear the bit, the signal must
33.11 SUPERV3 LIM
33.10 SUPERV3 ACT
33.11 SUPERV3 LIM
is activated. To clear the bit, the signal must fall
33.12 SUPERV3 LIM
falls below the value of parameter
6.14 SUPERV STATUS is activated. To clear the bit,
HI.
exceeds the value of parameter
is activated. To clear the bit, the
LO.
(see above)
33.09 SUPERV3
(see above)
33.09 SUPERV3 FUNC.
(see above)
33.09 SUPERV3 FUNC.
2.01 DI STATUS, bit 0).
2.01 DI STATUS, bit 1).
2.01 DI STATUS, bit 2).
Parameters and firmware blocks
147
falls
LO, bit 2 of 6.14
HI.
HI, bit 2 of 6.14
LO.
33.10
33.12 SUPERV3
33.10
33.11 SUPERV3 LIM
FUNC.
6.17 BIT