ABB ACSM1 Firmware Manual page 166

166
46.09 STALL FUNCTION
Selects how the drive reacts to a motor stall condition. A stall condition is defined as follows:
• The drive is at stall current limit
• the output frequency is below the level set by parameter
• the conditions above have been valid longer than the time set by parameter
Bit
0
1
2
46.10 STALL CURR LIM
Stall current limit in percent of the nominal current of the motor. See parameter
FUNCTION.
0 ...1600%
46.11 STALL FREQ HI
Stall frequency limit. See parameter
Note: Setting the limit below 10 Hz is not recommended.
0.5...1000 Hz
46.12 STALL TIME
Stall time. See parameter
0...3600 s
46.13 FAN CTRL MODE
Selects the fan control mode. Available in frame sizes A to D. See section
(0) Normal
(1) Force OFF
(2) Force ON
(3) Advanced
46.14 FAULT STOP MODE
Fault class selection for non-critical HW faults.
Use this parameter for configuring the following faults to the stop mode:
0003, 0005, 0007, 0008, 0011, 0012, 0015, 0024, 0025, 0029, 0030, 0036, 0038...0045, 0047...0051,
0053, 0054, 0057, 0059...0062, 0073, 0074, 0317.
Parameters and firmware blocks
FW block:
(46.10 STALL CURR
Function
Ena sup (Enable supervision)
0 = Disabled: Supervision disabled.
1 = Enabled: Supervision enabled.
Ena warn (Enable warning)
0 = Disabled
1 = Enabled: Drive generates an alarm upon a stall condition.
Ena fault (Enable fault)
0 = Disabled
1 = Enabled: Drive trips on a fault upon a stall condition.
FW block:
Stall current limit.
FW block:
46.09 STALL
Stall frequency limit.
FW block:
46.09 STALL FUNCTION.
Stall time.
FW block: None
Control mode based on the modulator ON/OFF status.
Fan is always OFF.
Fan is always ON.
Control mode based on measured temperatures of the power stage,
braking chopper and interface board.
FW block: None
FAULT FUNCTIONS (see above)
LIM), and
46.11 STALL FREQ
FAULT FUNCTIONS (see above)
FAULT FUNCTIONS (see above)
FUNCTION.
FAULT FUNCTIONS (see above)
HI, and
46.12 STALL TIME.
46.09 STALL
Fan control logic.