ABB 800xA Operation page 33

Section 3 CCF Displays
Figure 2. Loop Detail Display for a PID Loop
If you click on any field in the process values box, a Faceplate,
displayed. This faceplate enables you to change the setpoint and output values
displayed for the loop in the Loop Detail Display as well as other values and modes.
Reduced size faceplates,
the process bar graphs of the standard size faceplate,
faceplates for PID loops show measure, setpoint, output and other parameters as
determined by configuration such as bias, ratio, computer mode, feedforward and
feedback. Similarly, the Auto/Manual Ration/Bias (AMRB) loop does not show the
setpoint,
3BUR002418-600 A
– Enabled/disabled condition, limit value where applicable, and priority for
each alarm parameter (input, setpoint, deviation and output).
Figure
Figure 5.
3, provide the basic operator control actions without
Control and PID Loops
Figure 3, is
Figure 4. The reduced size
33