ABB 800xA Operation page 157

Section 7 I/O Displays
At the top of the display there is a section related to the addressing of the I/O
module.
Module Address Info
Devsub
Name
State
Lan
Station
Cluster
Device
Command Menu
Config
3BUR002418-600 A
This field is the controller DCN address where the S800
I/O is located.
This field shows the name of the AC460 Controller
Subsystem.
This field shows the status of the controller as ACTIVE,
DOWN and AVAIL.
This field represents the number of the Local Area
Network (LAN) of this station.
This field represents the number of the I/O Station.
This field represents the cluster number of the I/O
Station. Cluster 0 (zero) is the I/O modules connected
directly to the FCI. Clusters 1 - 7 are for remote optical
ModuleBus connections to the FCI.
This field represents the device number of the I/O
module of the cluster selected on this station.
Set a device condition by pointing to the COMMAND
drop down menu and selecting the desired action:
RESTART re-initializes the device,
DEACTIVATE forces all data qualities to 'bad' (used
if applications need to be informed while the device
is not ready to be used, for example, if maintenance
is being performed),
ACTIVATE sets data qualities based on the active
status of each channel.
Brings up the I/O Module Configuration Display
(AI810/AI890, AO810/AO890, DI810, DI820, DO810,
DO820), which gives the configuration for that module
and allows configuration changes. See
Runtime Templets on page 283.
S800 Device Display
Description
S800 I/O
157