Suzuki Baleno Manual page 831

17) Place compression spring for 2nd and 4th brake into transmis-
sion case.
18) Apply A/T fluid to new O-rings.
19) Assemble 2nd and 4th brake piston assembly.
a) Install rod washer, spring, brake piston and new E-ring to
1. E-ring
2. Brake piston
3. Spring
4. Rod washer
5. Piston rod
b) Install brake inner cover and new O-rings.
1. Brake inner cover
2. O-ring
20) Put 2nd and 4th brake piston spring in transmission case and
insert piston assembly and brake inner cover into case.
21) Apply valve lifter as shown figure and push piston cover.
Special Tool
(A): 09916-14510
(B): 09916-48210
22) Install snap ring by using snap ring plier (special tool) and re-
move special tools (A) and (B).
Special Tool
(C): 09900-06108
23) Check 2nd and 4th brake piston stroke.
For detail, refer to step 22) on "UNIT DISASSEMBLY" proce-
dure.
If its stroke is out of specification, select proper piston rod of
5 type (1) – (5) instead of original one and reinstall 2nd and 4th
brake piston assembly so as to be within specification.
brake piston rod.
AUTOMATIC TRANSMISSION 7B1-147