7B1-94 AUTOMATIC TRANSMISSION
1. Snap ring
2. 2nd and 4th brake piston assembly
3. SprIng
1. Transmission rear cover
28) Remove tools and take out 2nd and 4th brake piston assembly
and brake inner cover.
NOTE:
If 2nd and 4th brake piston assembly doesn't come out,
apply compressed air through oil hole (1) in figure of step
22)-b).
29) Remove spring.
30) Disassemble 2nd and 4th brake piston assembly.
a) Remove brake inner cover and O-rings.
1. Brake inner cover
2. O-ring
b) Remove E-ring, brake piston, spring and rod washer.
1. E-ring
2. Brake piston
3. Spring
4. Rod washer
5. Piston rod
31) Loosen six bolts of transmission rear cover.
32) Lightly and uniformly tap two rib sections of transmission rear
cover, using plastic hammer.
33) Remove ten bolts and engine mounting LH bracket.
NOTE:
Never reuse 2 bolts (a) after removal.
34) Pull out transmission rear cover with forward clutch subas-
sembly installed.
35) Remove 5 gaskets.
NOTE:
Never reuse removed gaskets.
1. Gasket
NOTE:
Never reuse removed O-ring.