Suzuki Baleno Manual page 1189

ALWAYS CARRY AIR BAG (INFLATOR) MODULE
WITH TRIM COVER (AIR BAG OPENING) AWAY
FROM BODY.
ALWAYS PLACE AIR BAG (INFLATOR) MODULE
ON WORKBENCH WITH TRIM COVER (AIR BAG
OPENING) UP, AWAY FROM LOOSE OBJECTS.
1. Slit on workbench
2. Workbench vise 3. Lower mounting bracket
17) Put on a pair of shop gloves to protect your hands from pos-
sible irritation and heat when handling the deployed air bag (in-
flator) module.
NOTE:
As a precaution, gloves and safety glasses are recom-
mended to prevent any possible irritation of the skin or eyes.
18) Disconnect the deployment harness from the air bag (inflator)
module as soon after deployment as possible. This will pre-
vent damage to the deployment harness due to possible con-
tact with the hot air bag (inflator) module canister. The
deployment harness are designed to be reused. They should,
however, be inspected for damage after each deployment and
replaced if necessary.
19) Carefully remove drop cloth from vehicle and clean off any
fragments or discard drop cloth entirely.
20) Repeat Steps 2) through 19) to deploy driver or passenger air
bag (inflator) module, if it does not try to deploy.
21) In the unlikely event that either or both of the air bag (inflator)
modules proceed immediately with Steps 23) through 25). If the
air bag (inflator) module did deploy, proceed with Steps 22).
22) With both air bags deployed the vehicle may be scrapped in
the same manner as a non-air bag equipped vehicle.
23) Remove the undeployed air bag (inflator) module(s) from the
vehicle. For driver air bag (inflator) module refer to Section
3C1, for passenger air bag (inflator) module refer to "ON-VE-
HICLE SERVICE" in this section.
WARNING:
D Always carry a live air bag (inflator) module with
trim cover away from you.
D When storing a live air bag (inflator) module or
when leaving a live air bag (inflator) module unat-
tended on a bench or other surface, always face
the bag up, away from the surface.
D This is necessary so that a free space is provided
to allow the air bag to expand in the unlikely event
of accidental deployment.
Failure to follow procedures could result in personal
injury.
24) Temporarily store the air bag (inflator) module with the air bag
opening facing up, away from the surface upon which it rests.
Refer to "SERVICE PRECAUTION" in this section for details.
25) Contact your local distributor for further assistance.
AIR BAG SYSTEM 9J-89