Suzuki Baleno Manual page 814

7B1-130 AUTOMATIC TRANSMISSION
Correct
Wrong
Wrong
1. Thrust needle roller bearing
1. Thrust needle roller bearing
5) Stake new lock nut for output shaft speed sensor, using stan-
dard punch in combination with hammer.
NOTE:
When staking lock nut for vehicle speed sensor, point a
suitable staking tool toward differential drive pinion shaft
axis center and stake lock nut securely, as shown in the
figure. (Poor staking may cause abnormal noise.)
1. Suitable
staking
tool
2. New
lock nut
3. Shaft
6) Apply A/T fluid to thrust needle roller bearing and race.
Race with bearing dimension
Outside diameter : Approximately 65.8 mm (2.59 in.)
Inside diameter
Thickness
7) Place thrust needle roller bearing and race to transmission
case.
8) Apply A/T fluid to thrust needle roller bearing and race.
Race with bearing dimension
Outside diameter : Approximately 45.7 mm (1.80 in.)
Inside diameter
Thickness
9) Place thrust needle roller bearing and race to transmission
case.
10) Install counter driven gear to transmission case.
: Approximately 51.0 mm (2.01 in.)
: Approximately 2.7 mm (0.11 in.)
: Approximately 30.0 mm (1.18 in.)
: Approximately 3.0 mm (0.12 in.)