Suzuki Baleno Manual page 678

7B-108 AUTOMATIC TRANSMISSION (3 A/T)
1. Direct clutch solenoid valve
2. 2nd brake solenoid valve
1. Solenoid valve wire clamp
2. Oil strainer
1. Oil pan
2. Magnet
1. cross slotted bolt
54) Connect 2 solenoid valve wires; one to direct clutch solenoid
valve and the other to second brake solenoid valve.
55) Install oil strainer and solenoid valve wire clamp.
Clamp solenoid valve wire by fastening solenoid valve wire
clamp with oil strainer bolt in the position as shown.
Tightening Torque
(i): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
56) Install magnet in oil pan and oil pan with new gasket.
i) Install magnet in oil pan right under oil strainer.
ii) Check to make sure that oil tubes are not in contact with oil
pan.
iii) There are 15 oil pan bolts in all and two of them have cross
slot in their heads. Mount these two cross slotted bolts in
such positions as shown in left figure after applying sealant
to their threads.
Tighten 15 oil pan bolts to specification.
"B": SUZUKI BOND No.1215, 99000-31110
Tightening Torque
(j): 5.0 N·m (0.5 kg-m, 4.0 lb-ft)
iv) Tighten oil pan drain plug to specification.
Tightening Torque
(k): 21 N·m (2.1 kg-m, 15.0 lb-ft)