External Control Connection Terminals, Frames R6 - ABB ACH580 Series Installation, Operation And Maintenance Manual

28
External control connection terminals, frames R6...R9
The layout of the external control connection terminals of frames R6...R9 is shown
below.
R6...R9
X1:1...3
X1:4...6
X1:7...9
X2
X3:1...3
X3:4...6
X4
X16
X12
WARNING! If installing modules, the +24 V AC cable to the control board ground
when the control board is powered using an external 24 V AC supply.
ACH580-01 Installation
1
2
3
X13
X5
S4, S5
X17
X14
ACH580 Installation, Operation and Maintenance Manual
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Digital inputs
X4 Safe torque off connection
Connection to embedded EIA-485
X5
fieldbus adapter module
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 External +24 V AC/DC input connection
X12 Panel connection
Option slot 1 (fieldbus adapter
X13
modules)
X14 Option slot 2 (I/O extension modules)
X16 Auxiliary fan 1 connection
X17 Auxiliary fan 2 connection
Termination switch (S4), bias resistor
S4, S5 switch (S5), see section
page
1 Panel port (control panel connection)
X10
Cold configuration connection. This
2 connector is used with the CCA-01
X8
configuration adapter.
3 Power OK and Fault LEDs
X7
X6
Switches
41
on