Tools Required; Flange Mounting - ABB ACH580 Series Installation, Operation And Maintenance Manual

10

Tools required

To install the ACH580 you need the following:
• Screwdrivers as appropriate for the mounting hardware used, including a
T20 Torx driver for drive cover removal
• Wire stripper
• Tape measure and/or provided mounting template
• Drill
• Frame sizes R5...R9: pallet truck and hoist
• Frame sizes R5...R9: The appropriate crimping tool for power cable lugs.
• Mounting hardware: screws or nuts and bolts. The type, length and quantity of
hardware depends on the mounting surface and the frame size:
R1...R2
R3
R5
R6...R9
WARNING! Before installing the ACH580, ensure the input power supply to the drive
is off.
WARNING! Metal shavings or debris in the enclosure can damage electrical
equipment and create a hazardous condition. Where parts, such as conduit plates
require cutting or drilling, first remove the part. If that is not practical, cover nearby
electrical components to protect them from all shavings or debris.

Flange Mounting

Frame size
R1
R2
R3
R4
R5
R6
R7
R8
R9
Further information is in Supplement: Flange mounting kit installation,
3AXD50000201877.
ACH580-01 Installation
ACH580 Installation, Operation and Maintenance Manual
Frame size
Kit
3AXD50000105311
3AXD50000105328
3AXD50000105335
3AXD50000031460
3AXD50000031461
3AXD50000018852
3AXD50000018853
3AXD50000018854
3AXD50000018855
Mounting hardware
M5 #10
M6 1/4 in.
M6 1/4 in.
M8 5/16 in.
Qty
4
4
6
4