GE N60 Instruction Manual page 139

5 SETTINGS
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first "Off" value. Since DNP /
IEC 60870-5-104 point lists must be in one continuous block, any points assigned after the first "Off" point
NOTE
are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the N60 is restarted.
NOTE
g) IEC 61850 PROTOCOL

PATH: SETTINGS PRODUCT SETUP
 IEC 61850 PROTOCOL

MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The N60 Network Stability and Synchrophasor Measurement System is provided with optional IEC 61850
communications capability. This feature is specified as a software option at the time of ordering. Refer to
the Ordering section of chapter 2 for additional details. The IEC 61850 protocol features are not available
if CPU type E is ordered.
The N60 supports the Manufacturing Message Specification (MMS) protocol as specified by IEC 61850. MMS is supported
over two protocol stacks: TCP/IP over ethernet and TP4/CLNP (OSI) over ethernet. The N60 operates as an IEC 61850
server. The Remote inputs and outputs section in this chapter describe the peer-to-peer GSSE/GOOSE message scheme.
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.

PATH: SETTINGS PRODUCT SETUP
 GSSE / GOOSE
 CONFIGURATION
MESSAGE
The main transmission menu is shown below:
GE Multilin N60 Network Stability and Synchrophasor Measurement System
 
COMMUNICATIONS IEC 61850 PROTOCOL
 GSSE / GOOSE
 CONFIGURATION
 SERVER
 CONFIGURATION
 IEC 61850 LOGICAL
 NODE NAME PREFIXES
 MMXU DEADBANDS

 GGIO1 STATUS
 CONFIGURATION
 GGIO2 CONTROL
 CONFIGURATION
 GGIO4 ANALOG
 CONFIGURATION
 GGIO5 UINTEGER
 CONFIGURATION
 REPORT CONTROL
 CONFIGURATION
 XCBR
 CONFIGURATION
 XSWI
 CONFIGURATION
 
COMMUNICATIONS IEC 61850 PROTOCOL
 TRANSMISSION

 RECEPTION

5.2 PRODUCT SETUP

GSSE/GOOSE CONFIGURATION
5
5-21