Set Date And Time - GE N60 Instruction Manual

CHAPTER 7: COMMANDS AND TARGETS
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a
command setting to "Yes" and pressing the
"No."
COMMANDS  CLEAR RECORDS  CLEAR IEC61850 XWSI OPCNT
 CLEAR IEC61850
 XWSI OPCNT
COMMANDS  CLEAR RECORDS  CLEAR IEC61850 XCBR OPCNT
 CLEAR IEC61850
 XCBR OPCNT
The Clear XSWI commands clear the disconnect operation counters for each phase and the three-phase counter. Similarly,
the Clear XCBR commands clear the circuit breaker operation counters for each phase and the three-phase counter.

7.1.3 Set date and time

COMMANDS  SET DATE AND TIME
 COMMANDS
 SET DATE AND TIME
The date and time can be entered on the front panel keypad. The time setting is based on the 24-hour clock. The complete
date, as a minimum, must be entered to allow execution of this command. The new time and date take effect when the
key is pressed.
ENTER
The clock also can be synchronized to the local computer time among several UR devices. Use the Synchronize Devices
entry in the Online Window area of the EnerVista software. (Click the button at the top of the window that opens.)
When the relay is synchronizing to an external time source such as PTP, IRIG-B, or SNTP, the manually entered time or the
manually synchronized time is over-written.
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CLEAR PMU 3 CONFIG

CHANGE COUNTER? No
CLEAR PMU 4 CONFIG

CHANGE COUNTER? No
CLEAR PMU 5 CONFIG

CHANGE COUNTER? No
CLEAR PMU 6 CONFIG

CHANGE COUNTER? No
CLEAR TELEPROTECT

COUNTERS? No
 CLEAR IEC61850

 XWSI OPCNT
 CLEAR IEC61850

 XCBR OPCNT
CLEAR ALL RELAY

RECORDS? No
key. After clearing data, the command setting automatically reverts to
ENTER
CLEAR XSWI 1

OpCnt? No

CLEAR XSWI 24

OpCnt? No
CLEAR XCBR 1

OpCnt? No

CLEAR XCBR 8

OpCnt? No
SET DATE AND TIME:

2000/01/14 13:47:03
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
See below
See below
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: YYYY/MM/DD HH:MM:SS
COMMANDS MENU
7
7-3