GE N60 Instruction Manual page 322

PRODUCT SETUP
— This setting assigns the FlexLogic operand serving to inhibit user-programmable pushbutton operation
PUSHBTN 1 LOCAL
from the front panel pushbuttons. This inhibit functionality is not applicable to pushbutton autoreset.
PUSHBTN 1 DROP-OUT TIME
programmable pushbutton active status after the front panel pushbutton or graphical front panel interface pushbutton
has been released. When activated remotely, this setting specifies the entire activation time of the pushbutton; the length
of time the operand selected by
PUSHBTN 1 LED CTL
setting is "Off," then LED operation is directly linked to the
pushbuttons 9 to 16 on the graphical front panel, where the label background shows the orange glow color for the "on"
state.
PUSHBTN 1 MESSAGE
programmed in the
off message that is programmed in the
graphical front panel.
When set to "Disabled", user-programmable pushbutton messages do not display. Otherwise the on message displays
when the user-programmable pushbutton becomes activated, and if in the "Latched" mode the off message displays when
the user-programmable pushbutton becomes deactivated.
When set to "Normal", the duration the message displays is as specified by the
When set to "High Priority", the duration of the off message is as specified by the
message is displayed as long as the user-programmable pushbutton is activated. While activated, target and other
messages are suppressed. To allow front panel keypad operation, when a keypad button is pressed the message is
supressed for 10 seconds.
PUSHBUTTON 1 EVENTS
5
event into the event recorder.
The figures show the user-programmable pushbutton logic.
5-128
— This setting applies only to "Self-Reset" mode and specifies the duration of the user-
remains on has no effect on the pulse duration.
PUSHBTN 1 SET
— This setting assigns the FlexLogic operand serving to drive the front panel pushbutton LED. If this
— This setting controls the behavior of the user-programmable pushbutton on message that is
and
PUSHBTN 1 ID PUSHBTN 1 ON TEXT
PUSHBTN 1 ID
— If this setting is enabled, each user-programmable pushbutton state change is logged as an
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
operand. This setting is not applied to
PUSHBUTTON 1 ON
settings, and the behavior of the user-programmable pushbutton
and settings. This settings has no effect on the
PUSHBTN 1 OFF TEXT
FLASH MESSAGE TIME
FLASH MESSAGE TIME
CHAPTER 5: SETTINGS
setting.
setting, but the on