NEC UNIVERGE SV8100 Features & Specifications Manual page 181

UNIVERGE SV8100
Program
Number
22-02-01
24-02-11
24-02-12
24-04-01
Trunk-to-Trunk Forwarding – DID (3) Trunk Forwarding by Department Groups
.
Refer to Departmental Calling for additional Department Group programming.
Program
Number
11-07-01
11-11-25
11-11-26
Call Forwarding, Off-Premise
Program Name
Incoming Call Trunk Setup –
Incoming Type
System Options for Transfer –
No Answer Step Transfer
System Options for Transfer –
No Answer Trunk-to-Trunk
Transfer
Automatic Trunk-to-Trunk
Transfer Target Setup
Program Name
Department Group Pilot
Numbers – Dial
Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Setup for Each
Extension Group
Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Cancellation for Each
Extension Group
Description/Comments
Used to assign the incoming trunk
type for each trunk. There is one
item for each Mode. When using
Trunk-to-Trunk Forwarding the
trunks must be set for Normal (0).
Assign the amount of time each
transfer destination rings before
step transfer is performed.
This timer defines the amount of
time that elapses before the
automatic Trunk-to-Trunk Transfer
is performed.
Assign the Speed Dialing number
bin (0~1999) to a trunk and the
mode which should be used as the
destination of the Automatic
Trunk-to-Trunk Forwarding.
Description/Comments
Assign pilot numbers to the
Extension (Department) Groups
you set up in Program 16-02.
Customize the service code to be
used to set the Automatic Trunk
Forwarding feature for a
Department Group.
Customize the service code to be
used to cancel the Automatic
Trunk Forwarding feature for a
Department Group.
Issue 5.0
Assigned Data
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
0~64800 (seconds)
(default = 10 seconds)
0~64800 (seconds)
(default = 0 seconds)
0~1999
(default = 1999)
Assigned Data
Up to eight digits
(default not assigned)
MLT, SLT
(default = 702)
MLT, SLT
(default = 703)
1 - 171