NEC UNIVERGE SV8100 Features & Specifications Manual page 988

Issue 5.0
Program
Number
13-04-04
13-04-05
14-01-04
14-01-05
14-01-13
20-06-01
20-07-05
1 - 978
Program Name
Speed Dialing Number and Name
– Transfer Destination Number
Speed Dialing Number and Name
– Incoming Ring Pattern
Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
Basic Trunk Data Setup –
Receive Gain Level for
Conference and Transfer Calls
Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
Class of Service for Extensions
Class of Service Options
(Administrator Level) – Set/
Cancel Automatic
Trunk-to-Trunk Transfer
Description/Comments
Use to store transfer destination
number data in the Speed Dialing
areas.
Use to store incoming ring pattern
data in the Speed Dialing areas.
Select the Transmit CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
Select the Receive CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
For each trunk, enter 1 to enable
loop supervision.
Assign a Class of Service (1~15)
to an extension.
Turn On (1) or Off (0) the ability of
an extension to use the
Trunk-to-Trunk Forwarding service
codes.
Tandem Trunking (Unsupervised Conference)
UNIVERGE SV8100
Assigned Data
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
*
#
1~9, 0, , , P, R, @
(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern
(1~4)
5 ~ 9 = Scale Pattern
(1~5)
(default = 0)
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 16 (-8dB)]
0 = Disable
1 = Enable
(default = 1)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 0 for
COS 1~15)