Mitsubishi Electric GOT2000 Connection Manual page 308


Precautions when preparing a cable
(8) Cable length
(a) The length of the RS-485 cable used for direct
connecting the indicating controller to the
communication converter
The length of the RS-485 cable must be 1200m or
less.
(b) The length of the RS-485 cable used for direct
connecting the indicating controller to GOT
The length of the RS-485 cable must be 500m or
less.
(9) GOT side connector
For the GOT side connector, refer to the following.
1.4.1 GOT connector specifications
(10)Shinko Technos indicating controller side connector
Use the connector compatible with the Shinko Technos
indicating controller side.
For details, refer to the user's manual of the Shinko
Technos indicating controller.

Connecting terminating resistors
(1) GOT side
Set the terminating resistor setting switch of the GOT
main unit to "100 OHM".
For the procedure to set the terminating resistor, refer
to the following.
1.4.3 Terminating resistors of GOT
(2) Shinko Technos indicating controller side
When connecting a Shinko Technos indicating
controller to the GOT, a terminating resistor must be
connected to the Shinko Technos indicating controller.
User's Manual of the Shinko Technos indicating
controller
10 - 14
10. CONNECTION TO SHINKO TECHNOS INDICATING CONTROLLER
10.3 Connection Diagram