ABB ACS550-01 User Manual page 32

32
The order of the tasks presented by the Start-up Assistant depends on your entries.
The task list in the following table is typical.
Language Select
Motor Set-up
Application
Option Modules
Speed Control EXT1
Speed Control EXT2
Torque Control
PID Control
Start/Stop Control
Protections
Output Signals
1. Select ASSISTANTS in the Main Menu.
2. Press UP/DOWN to select START-UP ASSISTANT.
Note! Rather than the Start-up Assistant, you can select Assistants for individual
tasks, such as Output Signals.
3. Make entries or selections as appropriate.
4. Press SAVE to save settings. Each individual parameter setting is valid immediately
after pressing SAVE.
Start-Up
Task name
Selects the language used in control panel displays.
Enters motor data and motor identification.
Selects an application macro.
Activates optional modules, if any, mounted on the drive.
• Selects the source for the speed reference.
• Sets the reference limits.
• Sets the speed (or frequency) limits.
• Sets acceleration and deceleration times.
• Sets up the brake chopper if activated.
• Sets the source for the speed reference.
• Sets the reference limits.
• Selects the source for the torque reference.
• Sets the reference limits.
• Sets the torque ramp up and ramp down times.
• Selects the source for the process reference.
• Sets the reference limits.
• Sets the speed (reference) limits.
• Sets the source and limits for the process actual value.
• Selects either EXT1 or EXT2.
• Defines the direction control.
• Defines the start and stop modes.
• Selects the use of Run Enable signal.
Sets the torque and current limits.
Selects the signals indicated through the relay outputs RO1, RO2, RO3 and
optional relay output's (if installed).
Selects the signals indicated through the analog outputs AO1 and AO2. Sets
the minimum, maximum, scaling and inversion values.
ACS550 User's Manual
Description