Other Modes; Access To Main Menu And The Other Modes - ABB ACS550-01 User Manual

30
To switch to local control (LOC) and control the drive using the control panel, press
and hold the
is displayed:
• Release the button while LOCAL CONTROL is displayed to set the panel
reference to the current external reference. The drive stops.
• Release the button when LOCAL, KEEP RUN is displayed, to copy the current
run/stop status and the reference from the user I/O.
To switch back to remote control (REM) press and hold the
REMOTE CONTROL is displayed.
Start/Stop – To start and stop the drive press the START and STOP buttons.
Shaft direction – To change the shaft direction press DIR (parameter 1003 must be
set to 3 (
Reference – To modify the reference (only possible if the display in the upper right
corner is highlighted) press the UP or DOWN buttons (the reference changes
immediately).
The reference can be modified when in local control (LOC), and can be
parameterized (using Group 11: Reference Select) to also allow modification when in
remote control (REM).
Note! The Start/Stop, Shaft direction and Reference functions are only valid in local
control (LOC) mode.

Other Modes

Besides the Output mode, the Assistant Control Panel has:
• Other operating modes that are available through the main menu.
• A fault mode that is triggered by faults. The fault mode includes a diagnostic
assistant mode.
• An alarm mode that is triggered by drive alarms.

Access to Main Menu and the Other Modes

To reach the main menu:
1. Press EXIT, as necessary, to step back through the menus or lists associated with a
particular mode. Continue until you are back to the Output mode.
2. Press MENU from the Output mode.
At this point, the middle of the display is a listing of the
other modes, and the top-right text says "Main menu"
3. Press UP/DOWN to scroll to the desired mode.
4. Press ENTER to enter the mode that is highlighted.
The following sections describe each of the other modes.
Start-Up
LOC button until first, LOCAL CONTROL, or later, LOCAL, KEEP RUN,
REM
)).
REQUEST
ACS550 User's Manual
LOC button until
REM