Lubrication; Greasing The Traction Unit - Toro 22306 Operator's Manual

Figure 21
1. Front screen
6. Remove the shoulder bolts and nuts securing
the oil cooler to the top of the front screen
(Figure 22).
Figure 22
1. Nut
2. Oil cooler
7. Remove the front screen.
8. When finished, install the front screen with the
4 bolts removed previously.
9. Install the oil cooler to the front screen with the
4 shoulder bolts and nuts removed previously.
10. Slide the heat shield between the frame and the
front weight and secure it to the front screen
grill using the carriage bolts and nuts removed
previously (Figure 20).
2. Bolts (left side bolt not
shown)
3. Front screen
4. Shoulder bolts
11. Tighten the bolts securing the front weight
(Figure 20).
12. Install the side screens and close the hood.

Lubrication

Greasing the Traction Unit

Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 23
and Figure 24).
Figure 23
27