Premaintenance Procedures; Removing/Installing The Hood; Lubrication; Greasing The Traction Unit - Toro 22318 Operator's Manual

Premaintenance
Procedures
Important: If you must tilting the machine more than
25 degrees, clamp off the vent hose on the top of the fuel
tank to prevent fuel from fouling the carbon canister.

Removing/Installing the Hood

Removing the Hood
Before performing many maintenance procedures, you will
need to remove the hood.
1. Raise the loader arms and install the cylinder locks.
Note: In the case that you need to remove the hood
without raising the loader arms, be very careful not to
damage the hood or hydraulic hoses as you maneuver
the hood out from under the arms.
2. Stop the engine and remove the key.
3. Release the four locking tabs
Figure 17
Top, left tab illustrated
4. Pull the hood off of the traction unit.
Installing the Hood
1. Position the hood over the traction unit frame with the
posts on the hood fitting into the holes in the frame
(Figure 17).
2. Secure the hood by pushing the locking taps forward
and down (Figure 17)
(Figure 17).

Lubrication

Greasing the Traction Unit

Service Interval: Before each use or daily (Grease
immediately after every washing)
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
Figure 19).
21
(Figure 18
G005291
Figure 18
Figure 19
and