Toro 22306 Operator's Manual page 14

Traction Control
To move forward, move the traction control
forward. To move rearward, move the traction
control rearward (Figure 5).
To turn, rotate the traction control in the desired
direction (Figure 5).
The farther you move the traction control in any
direction, the faster the traction unit will move in
that direction.
To stop, release the traction control.
Figure 5
Loader Arm/Attachment Tilt Lever
To tilt the attachment forward, slowly move the
lever to the right (Figure 6).
To tilt the attachment rearward, slowly move the
lever to the left (Figure 6).
To lower the loader arms, slowly move the lever
forward (Figure 6).
To raise the loader arms, slowly move the lever
rearward (Figure 6).
You can also push the lever fully forward into a
detent position (Figure 6) to release the loader
arms so that the attachment rests on the ground.
This allows attachments such as the leveler and
the hydraulic blade to follow the contours of the
ground (i.e., float) when grading.
Figure 6
1. Lower the loader arms
2. Raise the loader arms
3. Tilt the attachment
rearward
By moving the lever to an intermediate position
(such as, forward and left), you can move the
loader arms and tilt the attachment at the same
time.
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in the forward
direction, rotate the auxiliary hydraulics lever
rearward and pull it down to the reference bar
(Figure 7, number 1).
To operate a hydraulic attachment in reverse
direction, rotate the hydraulics lever rearward, then
move it left into the upper slot (Figure 7, number
2).
If you release the lever while in the forward
position, the lever will automatically return to the
neutral position (Figure 7, number 3). If it is in
the reverse position, it will remain there until you
pull it out of the slot.
Figure 7
1. Forward ow hydraulics
2. Reverse ow hydraulics
14
4. Tilt the attachment forward
5. Detent (Float) position
3. Neutral