Premaintenance Procedures; Removing/Installing The Hood; Lubrication; Greasing The Traction Unit - Toro 22318 Operator's Manual

Premaintenance
Procedures

Removing/Installing the Hood

Removing the Hood
Before performing many maintenance procedures, you
will need to remove the hood.
1. Raise the loader arms and install the cylinder locks.
Note: In the case that you need to remove the
hood without raising the loader arms, be very careful
not to damage the hood or hydraulic hoses as you
maneuver the hood out from under the arms.
2. Stop the engine and remove the key.
3. Release the four locking tabs (Figure 16, top, left tab
illustrated).
Figure 16
4. Pull the hood off of the traction unit.
Installing the Hood
1. Position the hood over the traction unit frame with
the posts on the hood fitting into the holes in the
frame (Figure 16).
2. Secure the hood by pushing the locking taps forward
and down (Figure 16)

Lubrication

Greasing the Traction Unit

Service Interval: Before each use or daily (Grease
immediately after every washing)
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 17 and
Figure 18).
22
G005291
Figure 17