Toro 22306 Operator's Manual page 6

• Avoid starting or stopping on a slope. If the
traction unit loses traction, proceed slowly,
straight down the slope.
• Avoid turning on slopes. If you must turn, turn
slowly and keep the heavy end of the traction
unit uphill.
• Do not operate near drop-offs, ditches,
or embankments. The traction unit could
suddenly turn over if a track goes over the edge
of a cliff or ditch, or if an edge caves in.
• Do not operate on wet grass. Reduced traction
could cause sliding.
• Do not park the traction unit on a hillside
or slope without lowering the attachment to
the ground, setting the parking brake, and
chocking the tracks.
Maintenance and Storage
• Disengage the auxiliary hydraulics, lower
the attachment, set the parking brake, stop
the engine, and remove the key. Wait for all
movement to stop before adjusting, cleaning,
or repairing.
• Clean debris from attachments, drives,
mufflers, and engine to help prevent fires.
Clean up oil or fuel spillage.
• Let the engine cool before storing and do not
store near flame.
• Do not store fuel near flames or drain indoors.
• Park the machine on level ground. Never allow
untrained personnel to service the machine.
• Use jack stands to support components when
required.
• Carefully release pressure from components
with stored energy.
• Disconnect the battery or remove the
spark plug wires before making any repairs.
Disconnect the negative terminal first and
the positive last. Reconnect positive first and
negative last.
• Keep hands and feet away from moving parts.
If possible, do not make adjustments with the
engine running.
• Charge batteries in an open well ventilated
area, away from spark and flames. Unplug the
charger before connecting or disconnecting it
from the battery. Wear protective clothing and
use insulated tools.
• Keep all parts in good working condition and
all hardware tightened. Replace all worn or
damaged decals.
• If any maintenance or repair requires the loader
arms to be in the raised position, secure the
arms in the raised position with the hydraulic
cylinder lock.
• Secure the loader arm valve with the loader
valve lock anytime you need to stop the
machine with the loader arms raised.
• Keep nuts and bolts tight. Keep equipment in
good condition.
• Never tamper with safety devices.
• Keep the traction unit free of grass, leaves,
or other debris build-up. Clean up oil or fuel
spillage. Allow the traction unit to cool before
storing.
• Use extra care when handling gasoline and
other fuels. They are flammable and vapors
are explosive.
– Use only an approved container.
– Never remove the gas cap or add fuel when
the engine is running. Allow the engine to
cool before refueling. Do not smoke.
– Never refuel the traction unit indoors.
– Never store the traction unit or fuel
container inside where there is an open
flame, such as near a water heater or
furnace.
– Never fill a container while it is inside a
vehicle, trunk, pick-up bed, or any surface
other than the ground.
– Keep container nozzle in contact with the
tank during filling.
• Stop and inspect the equipment if you strike
an object. Make any necessary repairs before
restarting.
• Use only genuine Toro replacement parts to
ensure that original standards are maintained.
• Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing.
Protect your face, eyes, and clothing when
working with a battery.
• Battery gases can explode. Keep cigarettes,
sparks and flames away from the battery.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
6