Setup; Charging The Battery; Checking Fluid Levels - Toro 22306 Operator's Manual

Setup

Step
1

Charging the Battery

No Parts Required
Procedure
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
1. Open the rear access cover.
2. Connect a charger to the battery (Figure 2) and
charge it for a minimum of 1 hour at 6 to 10
amps. Do not overcharge the battery.
4
2
Figure 2
1. Positive post
2. Negative post
3
1
G003792
3. Charger red (+) wire
4. Charger black (—) wire
Charging the battery produces gasses
that can explode.
Never smoke near the battery and keep
sparks and flames away from battery.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 2).
4. Close the rear access cover.
Step
2

Checking Fluid Levels

No Parts Required
Procedure
Before starting the engine for the first time, check
the engine oil and hydraulic fluid levels. Refer to
Operation for more information.
12