Parking Brake Lever
To set the parking brake, push the brake lever
forward and to the left and then pull it rearward
(Figure 8).
Note: The traction unit may roll slightly before
the brakes engage in the drive sprocket.
Figure 8
To release the brake, push the lever forward and
then right, into the notch.
Fuel Gauge
This gauge measures the amount of fuel in the fuel
tank.
Hydraulic Oil Temperature Light
(Dingo TX 425 only)
If the hydraulic oil gets too hot, this light
illuminates and an audible alarm sounds. If this
happens, stop the engine and allow the traction
unit to cool.
Hour Meter/Tachometer
When the engine is off, the hour meter/tachometer
displays the number of hours of operation that
have been logged on the traction unit. When the
engine is running, it displays the speed of the
engine in revolutions per minute (rpm).
After 50 hours and then every 100 hours thereafter
(that is at 150, 250, 350, etc.) the screen displays
CHG OIL to remind you to change the engine oil.
After every 100 hours, the screen displays SVC
to remind you to perform the other maintenance
procedures based on a 100, 200, or 400 hour
schedule. These reminders come on starting three
hours prior to the service interval time and flash
at regular intervals for six hours.
15