Siemens Sinumerik 840D sl Diagnostic Manual page 76

Overview of Alarms
NCK alarms
Definitions: This alarm is purely a development alarm. It only occurs with externally linked compile cycles.
Reaction: NC not ready.
The NC switches to follow-up mode.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Alarm reaction delay is cancelled.
Remedy: Consultation with CC developer
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
7202 Missing option bit for %1: %2 <hex>
Parameters: %1 = (string) name of the specific .elf file
%2 = (int) required option bit (hex)
Definitions: Alarm for SIEMENS compile cycles. This alarm appears when the option bit required for a SIEMENS
compile cycle is not set.
Reaction: NC not ready.
Channel not ready.
Interface signals are set.
Alarm display.
Alarm reaction delay is cancelled.
Remedy: Set the required option bit or delete the .elf file from the Flash File System.
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
7205 [Channel %1: ] Incompatible OEM transformation version NCK %2 CC
%3
Parameters: %1 = (int) channel number
%2 = Transformer interface version NCK
%3 = Transformer interface version OEM
Definitions: The interface for OEM transformations has changed incompatibly in the system.
Reaction: NC not ready.
Channel not ready.
Interface signals are set.
Alarm display.
Alarm reaction delay is cancelled.
Remedy: Load the new compile cycle version
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
7300 Problem with externally linked COA application %1 Index: %2 Additional
information: %3
Parameters: %1 = Name of the COA application
%2 = Index describing the problem that occured in more detail
%3 = Optional additional parameter
Definitions: A problem occurred while loading the COA application. This problem is described in more detail by
the parameters "Index" and "Additional information":
Index == 1: The interface version of the COA application is incompatible with the NCK version. The
additional information contains the interface version of the COA application.
Index == 2: The heap memory requested by the COA application is not available. The additional infor-
mation contains the heap memory requested in KB.
Index == 3: The $P_INCOAP parameters requested by the COA application cannot be created due to
insufficient memory. The additional information contains the heap memory requested in KB.
Reaction: Alarm display.
2-76
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009