Siemens Sinumerik 840D sl Diagnostic Manual page 193

03/2009
14159 [Channel %1: ] Block %2 more than two angles programmed with ROTS
or AROTS
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Frame rotations are described using space angles with the language commands ROTS or AROTS. A
maximum of two angles can be programmed.
Reaction: Correction block is reorganized.
Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Modify program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14160 [Channel %1: ] Block %2 tool length selection without geometry axis
specification
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If variant C (tool length acts on the programmed axis) is activated by machine data MD20380
$MC_TOOL_CORR_MODE_G43G44 for tool length compensation with H word and G43/G44 in
ISO_2 mode, at least one geometry axis must be specified.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change MD20380 $MC_TOOL_CORR_MODE_G43G44 or the part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14162 [Channel %1: ] Block %2 error %3 on activation of the CUTMOD function
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: An error occurred during the activation of the CUTMOD function. The type of error is more closely
defined by the error code number:
Error code
1No valid cutting direction is defined for the active tool.
2The edge angles (clearance angle and holder angle) of the active tool are both zero.
3The clearance angle of the active tool has an impermissible value (less than 0 degrees or greater
than 180 degrees).
4The holder angle of the active tool has an impermissible value (less than 0 degrees or greater than
90 degrees).
5The cutting tip angle of the active tool has an impermissible value (less than 0 degrees or greater
than 90 degrees).
6
cutting edge positions 1 through 4, the holder angle must be less than or equal to 90 degrees, with
cutting edge positions 5 through 8, it must greater than or equal to 90 degrees).
7
tolerance of about 1 degree) out of the active machining plane. As a result, the cutting edge position
is no longer defined in the machining plane.
With the aid of MD20125 $MC_CUTMOD_ERR, it can be determined for each of the named errors
whether the fault condition is to lead to the issue of an alarm, and whether the alarm is only to be dis-
played or also trigger a program stop.
Reaction: Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Correct the tool data of the active tool, or modify the part program in the case of error 7.
Alternatively, suppress all error alarms with the aid of MD20125 $MC_CUTMOD_ERR.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
The cutting edge position - holder angle combination of the active tool is impermissible (with
Impermissible rotation of the active tool (the tool was rotated through +/-90 degrees (with a
Overview of Alarms
NCK alarms
2-193