Siemens Sinumerik 840D sl Diagnostic Manual page 187

03/2009
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14129 [Channel %1: ] Block %2 orientation angles and orientation vector
components programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An orientation angle and components of an orientation vector were programmed at the same time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14130 [Channel %1: ] Block %2 too many initialization values given
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: On assigning an array by means of SET, more initialization values than existing array elements have
been specified in the program run.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reduce the number of initialization values.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14131 [Channel %1: ] Block %2 orientation axes and lead/tilt angles
programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An orientation angle and a leading or sideways angle were programmed at the same time.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14132 [Channel %1: ] Block %2 orientation axes incorrectly configured
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Possible causes:
- The configuration of the orientation axes does not match the machine kinematics. Also, for example,
when the position measuring system has not been set for the rotary axes.
- An axis that is required as orientation axis is currently not available as path axis.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adapt machine data.
Provide the required orientation axes using GET(..) or GETD(..).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-187